What is a Furnace Circuit or Control Board?
Furnaces use a circuit or control board to perform any number of activities from simply igniting your furnace to alerting you to problems within your unit. This "brain" within the furnace initiates and ends the heating operation, monitors the temperature and watches your furnace for signs of problems.
Types of Control BoardsFor a basic furnace, your control board will drive the operation of your ignitor, gas valve and flame sensor. These "simple ignition controls" are most common on older, less efficient units.
Integrated furnace controls, common on many high-efficiency furnaces today, lead the operation of many more activities. These might include the workings of the furnace blowers, as well as the onboard diagnostic system that provides you with troubleshooting information.
Control Board Operation
Typically, your control board kicks on the furnace ignition system (either a spark generator, glow coil or pilot light) after receiving a single from your thermostat that the temperature is too low. Once your ignitor is running hot, the control board gets gas flowing through the burners where that is ignited to start heating your home. Your control board then oversees the furnace's operation until it receives another signal from your thermostat that your home has reached the appropriate temperature.
Modern furnace control boards will shut the furnace off if something is wrong. For example, if your thermocouple is not detecting enough heat, the control board would then shut off the gas flow in order to prevent a possible leak.
If your control board performs self-diagnostics, it generally will alert you as to the nature of the problem through a specific failure code indicated by LED lights. To "crack" the code, simply refer to your furnace's owner's manual.
In some cases, what's wrong may be a problem with the control board itself. Your control board may be malfunctioning if you're able to test individual components for proper operation but your furnace won't heat on its own. You also can inspect your control board, generally located within the furnace's blower compartment, for burnt spots. It is possible to purchase a new control board from your furnace manufacturer; universal boards also exist. You also can contact your HVAC technician for questions about installing a new control board.