Trane XR95 Furnaces | FurnaceCompare®

Trane XR95 Furnace Overview

The Trane XR95 is a single-stage gas furnace offering up to 95 percent AFUE. Available in upflow/horizontal and downflow/horizontal configurations, the 11 models in this series output from 38,000 to 104,000 BTUH.

The XR95 features a direct-drive, four-speed blower motor and aluminized steel heat exchanger for maximum air circulation and efficient operation. A silicon nitride hot surface igniter, in-shot burners with multi-ports, direct vent, outdoor air option and a secondary heat exchanger are additional components of this furnace.

Exterior components of the unit include an insulated steel cabinet that protects the unit from environmental hazards and dampens operation noise, hinged blower doors with door latches and self-diagnostic controls. Accessories, such as a programmable thermostat, also are available.

Trane XR95 Furnace Prices

Your home’s size, location and installation complexity are just a few factors that will affect your total price, but we’re able to provide the average installed price across the U.S. to give you an idea of what to expect. 

Trane XR95 Estimated Installation Cost

FurnaceUnit CostInstalled Cost
Trane XR95 $1,900 $3,400

Compare Trane XR95 Furnace Pricing

Furnaces Unit Cost Installed Cost
Trane XR95 $1,900 $3,400
Trane S9V2VS $4,000 $5,500
Trane XC95m$5,000 $6,500
Trane XV95$ 3,300$ 3,300
Trane XT95 $2,400 $3,900
Trane XB90 $1,600 $3,100
Trane S9X2 $2,900 $4,400
Trane S9V2 $3,750 $5,250
Trane S8X1 $1,300 $2,800
Trane S8B1 $1,100 $2,600
Trane XB80 $900 $2,400
Trane XC80 $2,500 $4,000
Trane XV80 $2,500 $4,000
Trane XL80 $1,700 $3,200
Trane XT80 $1,100 $2,600

Find a Certified Heating & Cooling Professional In Your Area

Contact a top-rated local expert to help with all of your home’s HVAC needs.

New Installation vs Repair

Whether you should repair your furnace or replace it is one of the most commonly asked questions of HVAC professionals. The answer of course is different for each homeowner. Age, upkeep and how much you use it can all make a difference. However, there are a few basics to keep in mind that will help you make the best decision now and going forward. 

Financial Tip: Follow The 5,000 Rule
Multiply the age of the equipment by the repair cost, and if that exceeds $5,000, then replace the unit. If less, go ahead and repair it.  

Repair Your Furnace:

  • If it’s under 15 years old.
  • If it’s performing consistently.
  • If rated 87% AFUE or higher.

Replace Your Furnace:

  • If it’s over 15 years old.
  • If requires multiple repairs in last two years.
  • If energy bills increase suddenly.
  • If rated lower than 56% AFUE.

How we got these prices

The prices featured here represent the most common average prices nationwide of each Trane product. Prices may vary in your area. Unit Cost refers to the product price only. Installed Cost includes the product price and the national average installation price. 

A note about installed cost: Installation prices may increase 20-30% depending on where you live. If your project requires new ductwork, the installation cost will increase $1,500 – $2,000. 

What factors affect furnace pricing?

Because no two homes and home heating needs are exactly the same, the total installation cost of a new furnace will be different from place to place. Here are the factors that can affect the cost of installing a new furnace. If you want a true cost estimate for your home, talk to a local pro.

Local Climate and Region

If you live in the North, the heating capacity of your furnace needs larger than a similar sized home in the South where the winters aren’t as severe. 

Home Size and Construction

A large home will need a larger capacity HVAC system or multiple systems compared to a smaller home – which will increase your total installation costs. Also, a well insulated home retains warm or cool air and may not need as large a system as a poorly insulated home.

Project Complexity   

If your furnace installation is extra challenging or requires custom parts or retrofitting, your costs will go up. Examples include installing a furnace in a hard to reach or small space or in a historic home that needs updates.


Evaluating your home’s ductwork is part of any new installation because poor ductwork can negate all the energy savings features of a new furnace or air conditioner. Adding new ductwork can add $1,000 – $5,000 to a project depending on the size of home. 

Trane XR95 Model Numbers, BTUs and Efficiencies

The XR95 is available in different models which vary in efficiency and capacity.

Model NumberAFUEBTUs per Hour

XR95 Warranty

Trane provides a 10-year warranty on all internal functional parts and a lifetime warranty on the furnace’s heat exchanger. Units must be registered online or via phone within 60 days of installation to receive the full warranty terms. Extended warranty options, covering labor and other costs, also are available.

Furnace Filters for the Trane XR95

Air Flow ConfigurationCabinet WidthFilter Size(s)
Upflow14.5″14x25x1 (bottom)
17.5x25x1 (bottom)
Downflow14.5″Two 14x20x1
Upflow17.5″17x25x1 (bottom)
17.5x25x1 (side)
Downflow17.5″Two 16x20x1s
Upflow21″17.5x25x1 (side)
Downflow21″2 16x20x1s
Upflow24.5″17.5x25x1 (side)
24x25x1 (bottom)
Downflow24.5″Two 16x20x1s


When should I repair my furnace?

You should repair your furnaces if it’s under 15 years old, it’s performing consistently, and if rated 87% AFUE or higher.

When should I replace my furnace

You should fully replace your furnace if it’s over 15 years old, it has required multiple repairs in last two years, your energy bills increase suddenly, or if your furnace is rated lower than 56% AFUE.

The Trane XR95 will not come on. Unit tries but flashes 3 times. What does that mean?

According to the installation manual for the Trane XR95 3 flashing lights means Draft Pressure Error – Possible problems:
– Venting problem
– Pressure seitch problem
– Inducer problem

If this is the first time this year that your furnace has got the call for heat. It might be something as simple as a restriction in the vent tubing going from the inducer motor housing to the pressure switch, something as small as a spider or a spider egg. If there is a restriction the pressure switch will not make. If that switch does not make it will not allow the ignition process to occur. There could also be a restriction in the flu. Some furnaces this will be PVC, some furnaces the flu is round metal pipe. If there was a dead bird, a nest, or anything blocking the flu. That pressure switch will not make. The pressure switch is a safety in place to prevent your furnace from firing up. Turn off power to your furnace and if you are capable of removing the upper panel on the front of your furnace. Look for a rubber tube a little bigger than a straw. It will be hooked to a round plastic switch, a little smaller than a can of chew. Unhook the vent tube and blow through it and put it back on. Then remove the exhaust from the top of the furnace. Now turn the power back on. If it fires up immediately turn the furnace off and put the exhaust back on. Then turn the power back on. If it doesn’t start your flu is restricted.
Also on the inside of the upper panel there is usually a description of the diagnostic code’s. That’s the flashing of the LED lights, this will help you narrow it down.

What is the difference between the Trane XR and XV models?

The difference between the XR and XV models has to do with the blower motor. The XR models have a 4 speed blower motor while the XV models have variable speeds motor.

Questions about this model?

Consumer Reviews of Trane XR95


  • Very Satisfied
  • Somewhat Satisfied
  • Neutral
  • Somewhat Unsatisfied
  • Very Unsatisfied
  • #11 of 17 Trane Furnace
  • 20% of customers recommended

Read Reviews of Other Trane Products

Find ratings and reviews for Trane Air Conditioners, Boilers and more

Read Reviews

Top 10 Furnaces

See who made our list of the best Furnaces of 2022.

See the Top Products

Find a Certified Heating & Cooling Professional In Your Area

Contact a top-rated local expert to help with all of your home's HVAC needs.

Trane XR95 Furnace Reviews

Showing 1-5 of 10 reviews

"Blower Motor Burn out 9 yrs"

3.0 rating

Stay tuned it was just awesome to hear it’s under warranty

Lawrencville, GA

"Improper drain installation"

3.0 rating

Unit installed fall 2018. A/c part works great, heating operation not checked upon installation, my fault. Heating unit worked for a short period of time, then only a gurgling sound. It appears that the unit can be installed horizontally or vertical and the drain must be configured to match the direction. My hoses are configured for a vertical gravity drain, but my unit is installed horizontally, and upon investigation, I see there is no way water can travel up one foot to the drain junction box. There is a knockout plate right below the nipple from unit. This will allow for it to be installed in pvc to join ac drain water and heater drain water to go to pump and be pumped outside. Also, I am seeing that the heater drain water will not release unless I open cover and safety switch activates. I will then lock covers, unit will immediately fire up and work for a short period of time. My temporary solution was to knock out the kick out plate and run a short piece of hose from the nipple to a container. The unit is now running intermittently, but the drain needs to be permanently and correctly configured to match the horizontal installation.


"Worst piece of crap ever invented"

1.0 rating
Very Unsatisfied

From the moment I got it installed it was nothing but trouble. It stops working randomly (usually in the middle of the night or when nobody’s home). It keeps flashing 3 times (some kind of blockage). I called the installers back twice and it’s just as bad as before. Now I need to call a different company, maybe replacing the exhaust will work? Nobody knows. Look online at all the problems people are having. What good is this if it rarely ever works? I wish I had kept the previous furnace, at least that one could be fixed.

Kirkland, WA

"Furnace Review"

2.0 rating
Somewhat Unsatisfied

It hums and vibrates when it starts running I should stick to Lennox but it gets too old, I had it for 29 years but I can’t find anymore air filter so I bought a Trane from Home Depot and I am not happy about the change.

Edmonton, Alberta

"Will never install Trane again."

1.0 rating
Very Unsatisfied

This xr95 unit was defective at install. The defect was not identified until after the warranty date. Trane refused to assist in any warranty work or compensation for the part. Would not recommend anything made by Trane. My service provider also referred to their products as “trash”.

Cleveland, OH

HVAC Brands

Learn more about your home's heating and cooling system with our guides, how-to's, FAQ's, tips and more.

Ready to get a quote from an HVAC contractor?

Let us know what type of service you need and we can connect you with a certified local HVAC contractor.

Please enter a valid name

Please enter a valid phone number

Please enter a valid zip code

There are no dealers in this zip code.

Please enter a valid email address

Please select repair or replace

Please select heating, cooling or both