Miller Furnace Reviews

"wire melt down and unit break on control"

1.0 rating
Very Unsatisfied

Woke to smell of wire coating getting hot or melting down on an electric furnace that wasn't used but only 20 months and it was locked into emergency heat with the heating coils clicking!Wall hot as a stove and had to turn on air conditioning to cool down and heat just rolled out of duct work! Tried heat pump again and emergency heat came on and fan went off with heat strips still heating again and wall getting hot as hell! Had to leave on emergency heat to have heat and it not burn me up!! DON'T buy a miller furnace!!they do kill while you sleep and had friends that did and their kids!! not a lovely site!!

Buck Deer

Yosemite, KY

"Old but still working OK"

5.0 rating
Very Satisfied

This furnace appears to go back to at least the mid-eighties if not earlier (I am looking at one maintenance person's notes). For the most part it has worked fine, with a few occasions when a part wore out and had to be replaced – I think about 3 times in almost five years. The firing chamber blew out this year and that was a rather expensive repair, a couple thousand dollars I believe, the other repairs were more minor – worn wiring and the like, and cost a few hundred. I generally don't discuss furnaces with friends, I suppose if someone asked me directly what I had I would tell them, but "recommend" is a little overstating the case.

Philadelphia PA

"Mobile home install"

1.0 rating
Very Unsatisfied

Not really sure of model number. this is the nosiest furnace.. I replaced a 38 year old furnace in my mobile home that was very quiet. This one will actually wake you up !!!




1.0 rating
Very Unsatisfied

I bought this furnace from Willoughby Ohio Amana dealer, and it was shipped from New Vision Distribution in ft. Wayne, in. I also bought a central ac with coil and lineset. When the items arrived I checked all of the boxes for damage and there was none, so a few days later upon opening the furnace box we noticed the top right rear corner was bent and wringled and the blower moter was not in straight and it's flange was also bent. It had to have been done at the factory since the box was fine. They must have dropped it and went ahead and boxed it that way. [itiots] I was able to straighten the sheet metal and flange but took 2-3 hours of my time for that. The blower had to be loosened on the shaft and centered also. My installer finally got it working but I would never buy another furnace or ac without seeing it locally first. Buy a Coleman as this was so wide it barely fit where the old Coleman was at, and floor holes didn't even line up.

L. Leathem

N. Baltimore, OH

"M3RL060A BW"

2.0 rating
Somewhat Unsatisfied

I have a Miller Nordyne m3rl060a bw propane furnace. I had to replace the gas regulator last year. Last year I started using an excessive amount of fuel. I thought it was my propane gas fireplace. So, in preparation for the upcoming heating season, I started to investigate & found the inductor restrictor plate had disintegrated and was almost gone & that the comb. exit box had a cracked fitting from overheating.

ben brayley

lewiston, ny

HVAC Brands

Learn more about your home's heating and cooling system with our guides, how-to's, FAQ's, tips and more.

Ready to get a quote from an HVAC contractor?

Let us know what type of service you need and we can connect you with a certified local HVAC contractor.

Please enter a valid name

Please enter a valid phone number

Please enter a valid zip code

There are no dealers in this zip code.

Please enter a valid email address

Please select repair or replace

Please select heating, cooling or both