We speak HVAC so you don't have to
CONNECT with us!

our tools and detailed reports
can help you choose the best
furnace, boiler, heat pump or
central air conditioner.

See all questions

Where do u replace the filter?

Post created: 2013-04-07 Type of Equipment: Furnace Views: 273

This question was created on the page: https://www.furnacecompare.com/furnaces/york/diamond-90.html.

On 2013-04-11 JB wrote:

I found the following in the owner's manual for this furnace:



Most upflow furnaces have their filters located on the side or bottom of the

furnace, inside the blower compartment. Some models may have the filter located

in an accessory such as a single side return filter frame. If your furnace has a single side return filter frame accessory...slide the filters out of the accessory through the slot on its side.

To check filters located in the blower compartment, remove the blower compartment panel.


The spring-loaded safety

cutoff switch, mounted under the

blower deck in the control box will

automatically cut off the electrical

power supply to the furnace when

the blower panel is removed.

A filter mounted on the side of the furnace can be removed by pushing down

on the looped end of the wire filter retainer until it clears the lip of the furnace casing. The retainer may be swung toward the center of the furnace, exposing the filter for removal. Reverse the procedure to reinstall filters

Your Answer

Copyright 2002 - 2015 furnacecompare.com