We speak HVAC so you don't have to
CONNECT with us!

our tools and detailed reports
can help you choose the best
furnace, boiler, heat pump or
central air conditioner.

See all questions

My single stage furnace is blowing only cool air and the thermostat is not shutting off.

Post created: 2016-05-02 Type of Equipment: Furnace Views: 66

This question was created on the page: https://www.furnacecompare.com/furnaces/american-standard/freedom-80.html.

On 2016-05-02 Gary wrote:

Is there an LED light flashing an error code? This will help you diagnose the problem. If the light is flashing a code but you don't know what it means, there should be a sheet inside the front panel describing the error codes and their meanings. A problem like this is often caused by a dirty air filter, and other common causes are a faulty relay or circuit board.

We get a lot of questions in the forum about furnaces that blow cold air -- If you'd like to have a contractor take a look at this, we can help you find one, here.

On 2016-05-04 Diana wrote:

Hi Gary, thank you for your help.

LED light was flashing twice and code for that is external lockout. I did changed filter and clean the inside of furnace ( oh god a lot of dust ) ignition wasn't working before. But after replace filter and cleaning it started to work. But now I have another problem. I can not shut of from thermostat. Whenever I shut it off from thermostat, ignition, gas stops but not motor. It keeps running and after some time starts to blowing cold air. Do you think I need to replace thermostats too.

Thank you

Your Answer

Copyright 2002 - 2016 furnacecompare.com