Biasi B10 Boiler
Updated: Nov 8, 2018Write a review
Read more about Biasi Boilers
Overview of the B10
The Biasi B10 is a cast iron boiler that is both gas and oil burner compatible. The B10 is Energy Star compliant and has an efficiency of up to 87.2% AFUE. It features a 3-pass heat exchanger boiler design which contains three times as much interior surface area, allowing up to 40% fuel savings over conventional single pass boilers, according to the company. The B10 can be direct vented outdoors, meaning no flue is required. The unit also has an easy-access swing door for easy serviceability.
Date created: 2018-11-08
Name: Stan Wicks
Location: Hartford, CT
As a rep for a New England based wholesale distributor, I've experienced zero issues and zero warranties for the b10 series boiler when paired with a Riello oil burner. From time to time, controls, gauges, pumps, zone valves, etc.., will fail, but that's to be expected and not Biasi's fault. As for issues noted by prior reviewers, I'd have to assume the boiler is undersized for the home, improperly installed, or both, and it goes without saying quality fuel oil is a necessary ingredient for any oil burner to operate properly. Buy from a reputable/knowledgeable installer and enjoy the warmth & savings this boiler manufacturer offers.
Date created: 2018-10-20
Name: Gary Hall
Location: Casco, ME
I had this system installed 9 months ago. No matter how high I set the thermostat, the temperature will not get higher than 60 F. Guy has been here twice, still no luck!
Date created: 2017-04-12
Name: Gene J Desjardins
Location: Van Buren, ME
"So far so good"
I had a new boiler put in because old one froze and boiler cracked. I believe it's the highest btu out of the b10 series. It cost me $10,300 installed. I've had it 10 months now. Some of the radiators froze too in steel elbows which cracked and needed to be replaced. The heat is excellent as long as there is oil in tank. Jan 2017 took 175 gallons oil with one ton of pellets for pellet stove at 68 degrees. So I took thermostat down to 62 degrees and cut down heating oil to 175 gallons for February and March. The pellet stove used one ton for same time. My house is 3600 sq ft with all cathedral ceilings with highest point 16 feet. The furnace when really heating a lot makes loud popping sound when stops. My dad, daughter and mother in law had hot water furnace and theirs didn't make noise like that. The circulator pump started making intermittently a high pitch screeching humming noise. The contractor had not initially changed out the pump, because it was not leaking and still pumping. Just recently I demanded he install a new pump, because tired of hearing annoying noise and scared the pump will breakdown anytime. The contractor states I have to pay for pump. Anyway I have to say I can count on this furnace to heat on cold days. Hopefully the price of oil will not go up! What also annoys me is that the oil burner will start on and off to keep temp and pressure ready when heat is needed. I plan on turning it off this summer if it ever comes to Northern Maine.
Date created: 2015-06-12
Location: Dover, NH
"B10 cast iron oil fired boiler"
The B10 series cast iron low mass oil-fired boiler has been a great addition to my house. Paired with the Riello burner, I wouldn't choose anything over this boiler. I considered another Buderus but I am glad I went with the Biasi. Much more affordable, and for the same quality! I haven't had any issues whatsoever! It runs super quiet and my fuel bill has also decreased! It's been 5 years now and it's still running strong!
Date created: 2015-05-08
Name: M. Matson
Location: Laconia, N.H.
Great boiler. Very happy with installation.
Other B10 Reviews
Online reviews of the B10 on HVAC forums are largely positive. Multiple posts on heatinghelp.com refer to the B10 as an excellent unit and there are very few negative comments. There are a couple of comments about how small the unit is, which makes installation easier and provides less standby heat loss.
The warranty for the Biasi B10 boiler is comprised of the following:
- 1-year warranty on the boiler and casing
- Limited lifetime warranty on the boiler block to the original purchaser
Labor costs are not covered by the warranty.