I have a bryant plus 90 model 350MAV036040. My question is, when replacing flame sensor, limit switch and HSI, one has to remove the whole inducer blower assembly?
Post created: 2013-02-21 Type of Equipment: Furnace Views: 33This question was created on the page: http://www.furnacecompare.com/furnaces/bryant/legacy-plus90.html.
None so far, just trying to figure out how to replace them in case that would be necessary. i have done studying the electrical side, the sequence of events, the codes and how to troubleshoot all installed controls. thank you.
On 2013-02-22 JB wrote:
Hi,
I'm doing some research and will be back to you soon.
Your Answer
Copyright 2002 - 2013 furnacecompare.com
furnacecompare.com is provided "as is" and without warranty of any kind,
either express or implied, including, but not limited to, the implied warranties
of merchantability, fitness for a particular purpose, or non-infringement.
