Consumer Reviews of TEMPSTAR furnaces

Read more about TEMPSTAR furnaces

Read reviews of other Furnace brands

Write a review

<< Previous 1 2 3

---

Date created: 2009-02-09 Name: carol gallino
Location: Niagara, WI
Years owned: 15

Satisfaction Rating:
Review:
"c"
The heat exchanger was installed improperly in the factory. it was totally burnt out. we were being affixiated. lucky we are not dead. the furnace started making a funny noise so we called the repair man, he found the flaw. also had to replace the blower fan and once before another part.

---

---

Date created: 2009-01-15 Name: Sharon E. Stowers
Location: Pittsburgh, PA
Years owned: 7

Satisfaction Rating:
Review:
"Sharon STowers - this is a piece of junk"
I recommend not buying this furnace. Had to replace the blower 2 years ago and today on the coldest day of year, it is blowing cold air. Must stay in a hotel tonight. I have had furnaces that were not "high efficiency" that worked better than this piece of junk and lasted for years without a problem. I acquired this piece of junk furnace when I bought this home.

---

Date created: 2008-10-26 Name: Bob
Location: Northeast IL
Years owned: 18

Satisfaction Rating:
Review:
"Never Again!"
Builder installed this piece of junk. We've paid for repairs of several design defects. There was a product safety recall on this unit that the company never informed us about. When it failed, the secret recall was over, and we had to pay for the repairs. This defect could have killed us!

---

Date created: 2008-10-06 Name: R. Jarosz
Location: Brookfield, Il
Years owned: 10

Satisfaction Rating:
Review:
"Bob J."
The inducer went bad after just 1 yr. and again just 2 years ago. At over $300 each. Then every couple years the pilot light hole gets plugged and needs to be cleaned out at over $175 a time. The serviceman says there should be a filter preventing that but its not doing its job. All in all it was a bad choice of furnaces.

---

Date created: 2008-10-03 Name: Phil S
Location: Rochester, NY
Years owned: 11

Satisfaction Rating:
Review:
"big piece of junk"
I have had to replace 4 boards, two blower motors and the drain system fouls up all the time. If someone tries to sell you one of these pieces of junk run or kick the bum out. I have paid more in repair calls than the unit originally cost.

---

Date created: 2008-09-09 Name: Chris B
Location: Green Bay
Years owned: 7

Satisfaction Rating:
Review:
"7 yr old and junk"
Heat exchanger went out. It was still under warranty but would cost 500$ to install it. Dealer told me that they pressed the clam shell together at the factory wrong on all the units. If that’s the case, they should fix their screw up not at the cost of their customer. They will surely be out of business soon if that’s the way they operate.

---

Date created: 2008-06-19 Name: J Schaafsma
Location: Ontario, Canada
Years owned: 2

Satisfaction Rating:
Review:
"Tempstar N9MP2"
Darn noisy. Even when wired for the lowest speed fan setting, it wakes me up at night.

---

Date created: 2008-02-12 Name: M. Jones
Location: Buffalo, NY
Years owned: 11

Satisfaction Rating:
Review:
Tempstar DC90 - Replaced the igniter, blower, wiring. Now the burner looks to be uneven and has burnt the platic mesh at the top. 3 calls in the last 5 winters. Never again. Must go looking for a new furnace this summer.

<< Previous 1 2 3

The opinions expressed in these reviews are the opinions of consumers that submitted reviews to FurnaceCompare.com. They do not necessarily represent the opinions of FurnaceCompare.com.